WT6100CW

Configuration and exact-model context

WT6100CW is an impeller top-loader whose manual describes many conditions through a particular flashing panel light or light combination. Warm LED Blinks, Cold LED Blinks and Water Plus LED Blinks are distinct signals; the ordinary Water Plus selection is a separate use of the same control. Watch whether one lamp or a pair is flashing, and whether another light remains steady. Those observations are necessary because the washer may not show a two-letter fault code at all.

Physical fit and installation reading

For WT6100CW, LG lists a 27-inch width and a height of 57 1/4 inches with the lid raised. The overhead measurement matters more than the closed footprint if the washer sits below shelving. Leave room to lift the lid and reach into the impeller tub; a narrow shelf above the centre of the machine can interfere even when the sides fit. Water Plus is an ordinary option named on this model, whereas a blinking Water Plus light is interpreted through the diagnostic pattern in the manual. Keeping the installation drawing and the light table separate makes both easier to use.

How to read the documented signals

The manual assigns Water Plus LED Blinks a specific meaning: The load cannot be balanced for spinning. Its first documented response is to add items to a very small load. By comparison, Warm LED Blinks means water is entering too slowly or not at all. LG initially directs the owner to open the water taps fully. The two displays point to different checks even if the cycle stops in a similar way.

For Cold LED Blinks, LG writes that the washer is not draining properly; the first listed step is to clear or straighten the drain hose. The Rinse+Spin LED Blinks entry instead reports: The washer is automatically draining after a paused cycle. Its initial instruction is to allow the drain operation to finish. The distinction is in the complete displayed signal, rather than a broad symptom description.

Another entry, Control Lock LED ON, is explained this way: The control panel is locked. The associated first action is to turn off control lock using the control panel instructions for this model. Tub Clean LED Blinks has a separate explanation: The washer is asking for a Tub Clean cycle. For that indication LG starts with an instruction to run the tub clean cycle as described in the manual. The second is a status or maintenance message rather than a fault, a distinction worth preserving.

The LG manual also explains Door Lock LED Blinks: The lid did not lock. It first instructs the owner to close the lid and start the cycle again. For Heavy Soil and Cold LEDs Blink, the manual says the washer reported a motor fault; it first instructs the owner to let the washer stand for 30 minutes and try the cycle again. They identify different conditions even if both appear during the same general phase of use. The full display string or light pattern remains the most useful detail to record.