Signal or code
Error codes and display signals
The official manual linked for this model documents these messages. Some indicators apply only to variants that display them; each entry is labeled as a code, indicator, or status.
No matching signal for this model.
Model and error-code facts may be shown in the language of the original source.
Official PDF manual
Jump to manual pages
Open the official PDF at pages that document signals for this model.
MODEL OVERVIEW
About this model: GE JSP42CKCC
JSP42CKCC is a bisque 30-inch GE slide-in electric range with ribbon-heated ceramic glass, automatically locked self-clean oven and documented F function-error pattern.
Find the patterned-glass JSP42
JSP42CKCC is GE's 30-inch slide-in electric range with a self-cleaning oven and a patterned bisque-on-black ceramic-glass cooktop. Four ribbon heating elements sit beneath that surface. Its exact listing also gives a bisque full-width removable storage drawer and a large clear-view oven window. The linked owner's manual names JSP42 together with JSP46, so the family pages must be read alongside the CKCC details when choosing parts or describing a symptom. GE places the model label behind the open oven door at the lower left of the range frame; copy the whole designation and serial number. The glass cooktop is a defining difference from coil-top JSP39, whose plug-in elements and lift-up porcelain top are constructed differently. Cooktop cleaner, surface unit, drawer and oven-control questions each involve distinct components. A person looking at the display should not assume that every lit cooktop lamp denotes a failed oven, even though all of them belong to one range.
Interpret radiant-surface indications
GE lists traditional oven cooking technology for JSP42CKCC, not a convection mode. For the ceramic-glass surface it lists four hot-surface indicators. Page 6 says a HOT SURFACE light can stay on after its radiant unit is turned off until the glass cools to about 150 degrees Fahrenheit. That is a residual-heat warning, particularly important because the transparent-looking surface remains hot. Page 7 explains another normal protection behavior: a temperature limiter may switch a radiant element off temporarily if a pan boils dry, has an uneven bottom, sits off-center or is absent. Use flat cookware matched to the zone rather than assuming the oven control has failed when heating cycles. The right-front dual surface drawing describes small and large settings for cookware sizes. Separately, page 15 offers a thermostat offset for baking and roasting temperatures; that setting does not change broiling or self-clean heat. Surface limiting and oven-temperature adjustment are different functions and should be reported separately.
Prepare the automatic-lock clean cycle
The oven's self-clean door lock is automatic according to the exact GE specification. The owner guide first asks for racks, broiler pan and grid, cookware and foil to be removed, with heavy spillovers wiped from the bottom. Avoid scrubbing the door gasket. On this control, SELF CLEAN LO/STD once selects four hours and twice selects three hours; the longer choice suits a dirtier cavity while the shorter one suits small contained spills. A delayed start can be set after the clock has the correct time. Once START is pressed, the door locks and the display can show the programmed start. It remains shut until the cavity drops below its lock temperature and the LOCKED light turns off. This automatic lock differs from a neighboring model with a manual lever; there is no user-operated JSP42 latch to push right. Let the oven cool before touching ash or attempting the door. Normal locking during a hot cleaning cycle is not an F code by itself.
Follow the F troubleshooting sequence
On page 10, the oven display's F followed by a number or letter with control signal is defined as a function error. The troubleshooting row on physical page 29 instructs CLEAR/OFF and a new attempt; if the code repeats, cut range power for at least thirty seconds, reconnect and request service if it appears again. Note the entire suffix and whether cleaning, ordinary baking or another operation was underway. The guide does not claim that one particular F suffix proves a failed thermostat, lock or circuit board. An oven that will not self-clean while still too hot should first be allowed to cool before controls are reset. A clock flashing after a power outage is a separate condition requiring time and interrupted cooking functions to be set again. A blank clock can also result from the display black-out setting or the supply breaker. Tell service which indication came from the oven display and which was a cooktop hot-surface lamp; that distinction prevents the two systems from being conflated.
Verified model details
Exact GE data show four ribbon elements under a patterned bisque-on-black glass surface.
Source for this detail · Source page: 1Hot-surface lamps and temporary temperature-limiter cycling concern the cooktop, not the oven F display.
Source for this detail · Source page: 29Self-clean uses an automatic door lock with three- or four-hour choices.
Source for this detail · Source page: 16
This description summarizes the linked source documents; check each cited source for your exact model and region.
Manufacturer source
Open official source
GE® 30" Slide-In Electric Range with Self-Cleaning Oven - JSP42CKCC - GE Appliances
Open official sourceIf there is a safety risk, stop using the appliance and follow the manufacturer’s instructions.