Signal or code
Error codes and display signals
The official manual linked for this model documents these messages. Some indicators apply only to variants that display them; each entry is labeled as a code, indicator, or status.
No matching signal for this model.
Model and error-code facts may be shown in the language of the original source.
Official PDF manual
Jump to manual pages
Open the official PDF at pages that document signals for this model.
MODEL OVERVIEW
About this model: GE JGSP44CEYCC
JGSP44CEYCC is a bisque GE Profile slide-in gas range with glass cooktop, round taupe grates, automatic self-clean door lock, two-rack oven and a documented F-plus-character function alert.
Identify this bisque Profile variant
JGSP44CEYCC is a GE Profile 30-inch slide-in gas range in Bisque on Bisque, with a glass cooktop and round taupe cast grates. Those exact product facts are important because its owner-manual cover is shared with JGSP22 and JGSP23. A guide drawing of one surface or lower compartment should not silently be transferred to every suffix. GE specifies sealed burners and a 16,000-BTU natural-gas bake/broiler rating for this model. The glass surface deserves its own cool-down and cleaning approach, separate from tending the burner heads and round grates. This is a built-in-looking slide-in range, not a standalone wall oven, and any replacement part needs the full CEYCC suffix to match the bisque trim. When recording a fault, identify whether the problem is at the burner, the oven display, or the door. The shared PDF verifies the JGSP44 family, while the exact GE page establishes its materials, appearance and automatic lock equipment.
Understand the clock and Cook and Hold
The oven has two racks and an electronic clock and kitchen timer, plus GE's Delay Bake with Cook and Hold. Page 17 explains that the clock must show correct time for automatic oven timing, and it cannot be changed during timed baking or a self-clean cycle. The kitchen timer is only a minute counter: it can be set up to nine hours and fifty-nine minutes, but does not itself run the oven. COOKING TIME and DELAY START on the control page are different commands; START completes an actual cooking or cleaning selection. If a household outage leaves time flashing, reset the clock and any planned work before judging the delay function. Cook and Hold is a product feature, not a diagnostic message. Note whether a cooking program was delayed, had reached its start time or was merely timed by the kitchen counter. A failure to heat with an unset clock and a true F alert may produce very different reports even though both involve the same display.
Let the oven lock itself for cleaning
For this JGSP44, GE confirms an automatic self-clean oven-door lock. Physical PDF page 20 says to begin with a cool cavity, remove broiler pan, grid, cookware and foil and wipe heavy spills. Select SELF CLEAN, adjust from the normal four hours to a permitted three-to-five-hour interval if needed and press START. The door then locks by itself. It stays shut until the temperature falls below the unlocking point and the LOCKED DOOR lamp goes off. If the owner forgot to close the door, LOCK DOOR flashes and the control signals. That is a setup condition to correct, rather than a numbered F code. This differs from models whose instructions require pushing a mechanical latch across by hand. Never force an electronically locked hot door. The glass cooktop, oven gasket and cavity each have different care needs; the guide says not to use abrasive oven cleaner during the high-temperature cleaning cycle.
Separate F from LOCK DOOR
The actual function-error statement is on physical page 10: F followed by a number or letter flashes and the oven control signals. Press CLEAR/OFF, allow the oven to cool for an hour and put it back into operation. If F repeats, disconnect power to the oven and call for service. No precise off-time or mapping from suffix to a broken component appears on that page. Describe whether the message arrived during ordinary bake, delay operation or self-clean, and whether the door was already closed. A flashing time after an outage needs clock reset, while LOCK DOOR during an attempted clean points to the open door. Neither should be reported as an extra F character. Tell the technician JGSP44CEYCC, the entire display and the stage of the cycle. Because JGSP23 shares the cover but has different exact product materials and equipment, use this model's own glass-top and automatic-lock context when seeking advice.
Verified model details
Its exact glass cooktop and cast round grates distinguish it from the JGSP23 variant on the shared cover.
Source for this detail · Source page: 1Self-clean locks the door automatically; LOCK DOOR when open is a setup signal.
Source for this detail · Source page: 10F is a separate function error treated with CLEAR/OFF, cooling and service after recurrence.
Source for this detail · Source page: 20
This description summarizes the linked source documents; check each cited source for your exact model and region.
Manufacturer source
Open official source
GE Profile™ 30" Slide-In Gas Range - JGSP44CEYCC - GE Appliances
Open official sourceIf there is a safety risk, stop using the appliance and follow the manufacturer’s instructions.