MODEL PROFILE

Washing machine / GE

GFW148SSMWW

Find the official source for this exact appliance model.

Signal or code

Error codes and display signals

The official manual linked for this model documents these messages. Some indicators apply only to variants that display them; each entry is labeled as a code, indicator, or status.

Model and error-code facts may be shown in the language of the original source.

Official PDF manual

Jump to manual pages

Open the official PDF at pages that document signals for this model.

MODEL OVERVIEW

About this model: GE GFW148SSMWW

GFW148SSMWW front-load washer messages CLrFLtr, H2O supply, Door and CAnCELEd with model-specific maintenance.

Identify the compact washer and its display

GFW148SSMWW is GE's white, 24-inch front-load washer with a 2.4-cubic-foot stainless-steel basket. Its exact product listing gives 14 cycles, steam, a 1400-RPM maximum spin and an electronic touch control with LED countdown. The linked owner's manual names the GFW148 family on the cover and illustrates the corresponding FILL, WASH, RINSE and SPIN display on page 5. It does not print this full sales suffix, so the precise capacity and finish come from the exact product page. Wi-Fi is listed only with the optional PBX23W00Y1 part; a missing connection is not, by itself, one of the manual's Consumer Help Indicator messages.

Source for this detail · geappliances.comSource for this detail · images.salsify.com · Source page: 1Source for this detail · images.salsify.com · Source page: 5

A wet load does not automatically mean a fault

The exact model has load-sensing adaptive fill and an internal water heater, but the manual still asks for loosely placed laundry and HE detergent. Pods belong in the basket before the clothes, not the dispenser. If the washer senses an uneven load, the SPIN light blinks while it tries to rebalance; it can remain lit briefly after the cycle. The manual says the machine may then finish without reaching full spin speed. For unusually wet clothes, redistribute the items and run Rinse+Spin with both rinse selections turned off. When adding an item mid-cycle, use Start/Pause and allow up to 30 seconds for the door to release; do not force the latch.

Source for this detail · geappliances.comSource for this detail · images.salsify.com · Source page: 5Source for this detail · images.salsify.com · Source page: 11

Read CLrFLtr and H2O supply as different checks

Page 22 calls these Consumer Help Indicator messages: they offer owner checks rather than a full service-code dictionary. CLrFLtr is a slow-drain notice during spin or drain. GE directs the owner to switch off the washer, shut off water and clean the pump filter. The filter is behind the small bottom-right front door; the short drain hose should empty into a shallow pan before the filter is unscrewed. Page 19 also names a kinked hose, clogged household drain and a siphoning hose pushed too far into the standpipe, where an air gap is needed. H2O supply instead means water is not entering. Check both household supply valves. Its four-minute control lockout must expire; unplugging to evade it starts that timer again.

Source for this detail · images.salsify.com · Source page: 12Source for this detail · images.salsify.com · Source page: 19Source for this detail · images.salsify.com · Source page: 22

Door and CAnCELEd describe operating history

Door appears after three cycles have been started without opening the washer door; another cycle waits until the door is opened. That reminder differs from a door-lock failure. CAnCELEd has several documented routes: the machine was paused longer than 24 hours, water remained inside for 15 minutes while the door was open, or a cycle stopped before completion because of certain faults. The manual says the controls enter a lockout when this message scrolls and that Power or unplugging can bypass that particular lockout. Those actions clear the pause state; they do not prove that any underlying drain or supply problem has gone away. Record the displayed text before changing anything.

Source for this detail · images.salsify.com · Source page: 22

Prevent a second drain or seal problem

GE includes fill and drain hoses with GFW148SSMWW, but the maintenance page still calls for regular inspection and replacement of all inlet hoses after five years. Clean the pump filter every month: drain water through its small hose into a pan, rinse debris from the removed filter, refit it and close the access door. Inspect the flexible door gasket for trapped objects and blocked holes, and use an empty Tub Clean cycle roughly monthly. If drainage remains weak after filter cleaning, page 19 points to hose routing and household plumbing as separate possibilities. A CLrFLtr message therefore should not be interpreted as proof that the motor or electronics have failed.

Source for this detail · geappliances.comSource for this detail · images.salsify.com · Source page: 12Source for this detail · images.salsify.com · Source page: 19

Verified model details

This description summarizes the linked source documents; check each cited source for your exact model and region.

Manufacturer source

Open official source

Official source linked

GE® ENERGY STAR® 24" 2.4 Cu. Ft. Front Load Washer with Steam - GFW148SSMWW - GE Appliances

Open official source

If there is a safety risk, stop using the appliance and follow the manufacturer’s instructions.

← Back to all models